Result Point
The result points interface gives the user control over what locations results are displayed at. For initial and final stages the user has the ability to add in locations to display both section views and to add rows to their tables. Eriksson Beam will always display a base number of rows in tables and also add in the controlling row. All result locations require it to also be an analysis point (see Analysis Points) and will automatically create analysis points for the user.
Inputs
The inputs for analysis points can be found at File Menu → Result Points.
Input Name | Description |
|---|---|
Selected Case | The user selects from the below cases in order to edit the additional result locations. Available cases for editing include: Initial Stresses, Initial Flexure, Initial Shear, In-place Stresses, In-place Flexure, In-place Shear. |
Base Table Rows | The minimum number of rows that will be added to the table. If the assumed symmetry option is selected, this number will be halved. |
Assumed Symmetry | Assumes the geometry, reinforcement, and loading is symmetric. If checked, the program will only display results from 0 to 0.5 L. Eriksson Beam does not check to confirm that symmetry is present. |
Relative Location | The location of the analysis point measured as a percentage down the member length. |
Absolute Location | The location of the analysis point measured from the start of the member. |
Table Entry | Add a row at this location in the corresponding tables. |
Section View | Add a section view at this location in the corresponding sections. |